|
V
|
setup pin -> GND at power on
|
module enters setup mode
|
|
next pin -> GND
|
module shows raw analog digital converter
readings.
ADC0 with 12bit accuracy. The display shows
"a0:" followed by numbers between 0 and 4092.
|
|
next pin -> GND
|
Module shows "D:" and you can use the
pins "+" and "-" to change the value for
the divider. Touch "+" or "-" with a GND
connected wire to step the value up or down
and connect the wire for a longer time to
fast scroll up or down.
|
|
next pin -> GND
|
Module shows "M:" and you can use the
pins "+" and "-" to change the value for
the multiplier. The handling is the same
as described above for "D:".
|
|
next pin -> GND
|
Module shows "A:" and you can use the
pins "+" and "-" to change the value for
the add or subtract constant.
The handling is the same as described above
for "D:".
|
|
next pin -> GND
|
Module shows "P:" and you can use the
pins "+" and "-" to change the value for
the amount of digits behind decimal point.
The handling is the same as described above
for "D:".
|
|
next pin -> GND
|
Module shows "c0:none" and you can use the
pins "+" and "-" to change the "none" into
a letter (can be used to display the
measurement unit).
Possible letters are one of the following:
ABCDEFGHIJKLMNOPQRSTUVWXYZ '%$
abcdefghijklmnopqrstuvwxyz
Note: programming c0 to none means not showing
any units indepdent of what values are set for
c1 and c2. You should program c0 to a single space
character if you want a bit of space between the
digits and the measurement unit.
|
|
next pin -> GND
|
Module shows "c1:none" and you can use the
pins "+" and "-" to change the "none" into
a second letter (can be used to display the
measurement unit).
|
|
next pin -> GND
|
Module shows "c3:none" and you can use the
pins "+" and "-" to change the "none" into
a second letter (can be used to display the
measurement unit).
|
|
next pin -> GND
|
The values are stored permanently in
EEPROM and the module shows "done" in
the display. Power-cycle the module.
|